Rattle, Clunk, or Shudder Noise from the Power Steering System (Two-Mode)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you review the Power Steering System General Description and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - Power Steering System |
| 2 | Verify that a rattle, clunk or shudder noise is present. Is a rattle, clunk or shudder noise present? |
Go to Step 3 | System OK |
| 3 | Inspect the power steering gear bushings for ware or damage. Are the power steering gear bushings worn or damaged? |
Go to Step 8 | Go to Step 4 |
| 4 | Inspect the power steering gear for proper installation. Refer to Steering Gear Replacement (Rack and Pinion) or Steering Gear Replacement (Non-Rack and Pinion) or Steering Gear Replacement (Two Mode Hybrid) . Is the power steering gear installation correct? |
Go to Step 5 | Go to Step 9 |
| 5 | Inspect the steering linkage. Refer to Steering Linkage Inner Tie Rod Inspection and Steering Linkage Outer Tie Rod Inspection . Did you find and correct the condition? |
Go to Step 12 | Go to Step 6 |
| 6 | Inspect the suspension. Is the suspension worn? |
Go to Step 10 | Go to Step 7 |
| 7 | Inspect the intermediate shaft. Is the intermediate shaft worn? |
Go to Step 11 | Go to Step 3 |
| 8 | Replace the power steering gear. Refer to Steering Gear Replacement (Rack and Pinion) or Steering Gear Replacement (Non-Rack and Pinion) or Steering Gear Replacement (Two Mode Hybrid) . Did you complete the repair? |
Go to Step 12 | - |
| 9 | Install the power steering gear correctly. Refer to Steering Gear Replacement (Rack and Pinion) or Steering Gear Replacement (Non-Rack and Pinion) or Steering Gear Replacement (Two Mode Hybrid) . Did you complete the repair? |
Go to Step 12 | - |
| 10 | Replace the worn suspension components. Refer to Diagnostic Starting Point - Suspension General Diagnosis
. Did you complete the repair? |
Go to Step 12 | - |
| 11 | Replace the intermediate shaft. Refer to Upper Intermediate Steering Shaft Replacement or Steering Shaft Coupling Replacement . | Go to Step 12 | - |
| 12 | Operate the system in order to verify the repair. Did you correct the condition? |
Go to System OK | Go to Step 3 |