Trim Height Measurements
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Trim height is a predetermined measurement relating to vehicle ride height. Incorrect trim heights can cause bottoming out over bumps, damage to the suspension components, and symptoms similar to wheel alignment problems. Check the trim heights when diagnosing suspension concerns and before checking the wheel alignment.
Perform the following before measuring the trim heights:
- Ensure the vehicle is on a level surface, such as an alignment rack.
- Set the tire pressures to the pressure shown on the certification label. Refer to Vehicle Certification, Tire Placard, Anti-Theft, and Service Parts ID Label .
- Ensure that the suspension is fully supporting the vehicle.
- If the vehicle is equipped with automatic level control, ensure that the system is functioning properly.
- Check for installed after market accessories or modifications that could affect trim height measurements:
- Tire and wheel sizes other than production
- Lifting or lowering kits
- Ensure that the passenger and rear compartments are empty, except for the spare tire.
- Check the fuel level. Add additional weight if necessary to simulate a full tank of fuel. (One U.S. gallon of gasoline weights approximate 6.5 lbs. One liter of gasoline weights 0.70 kg)
- Close all doors, lift gate/trunk and the hood.
- Remove the alignment rack floating pins.