Stabilizer Shaft Insulator Replacement (1500)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Stabilizer Shaft Insulator (1500)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
1	Stabilizer Shaft Clamp Bolt (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 50 N.m (37 lb ft)
2	Stabilizer Shaft Clamp
3	Stabilizer Shaft Insulator Tip: Ensure that the slit in the stabilizer shaft insulator is installed toward the rear of the vehicle.