LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Rear Drive Axle) >> Repair Instructions >> Vent Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Make note of the routing in order to aid in reassembly.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Vent Hose Removed From Rear Axle
    GM788622Courtesy of GENERAL MOTORS CORP.
  2. Remove the vent hose from the top of the rear axle.
    3. Fig 2: Vent Hose Removed Clip Attached To Frame
    GM788624Courtesy of GENERAL MOTORS CORP.
  3. Remove the vent hose from the clip attached to the frame.
scientia non olet · About LEMON Manuals