LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Rear Drive Axle) >> Repair Instructions >> Vent Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Vent Hose Removed Clip Attached To Frame
    GM788624Courtesy of GENERAL MOTORS CORP.
  1. Install the vent hose to the clip attached to the frame.
    • Route the same way as when removed.
    • Ensure that the hose is free of kinks and is routed clear of sharp objects.
    • Ensure that the vent is not plugged.
    2. Fig 2: Vent Hose Removed From Rear Axle
    GM788622Courtesy of GENERAL MOTORS CORP.
  2. Install the vent hose to the top of the rear axle.
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals