LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Shaft Seal and/or Bearing Replacement (8.6, 9.5 LD Axles) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Axle Shaft Bearing & Installation Tools J 23690 Or J 29709 & J 8092
    GM695758Courtesy of GENERAL MOTORS CORP.
  1. Install the axle shaft bearing using the J 23690  (1) and the J 8092  (2).
  2. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
    3. Fig 2: View Of Axle Shaft Seal & J 21128
    GM885624Courtesy of GENERAL MOTORS CORP.
  3. Install the axle shaft seal using the J 21128  .
  4. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
  5. Install the axle shaft. Refer to Rear Axle Shaft Replacement .
  6. Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.6 Inch axle)  or Rear Axle Housing Cover and Gasket Replacement (10.5 Inch Axle) .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Fill the rear axle. Refer to Rear Axle Lubricant Replacement (8.6 Inch Axle)  or Rear Axle Lubricant Replacement (10.5 Inch Axle) .
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals