LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Lubricant Replacement (10.5 Inch Axle) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Fig 1: View Of Rear Axle Fill Plug
    GM392774Courtesy of GENERAL MOTORS CORP.
  3. Remove the rear axle fill plug.
  4. Fig 2: Rear Drive Axle Drain Plug
    GM390113Courtesy of GENERAL MOTORS CORP.
  5. Remove the rear axle drain plug.
  6. Drain the lubricant into a suitable container.
  7. Inspect the drain plug for excessive metal particle accumulation. This accumulation is symptomatic of extreme wear.
  8. Clean the drain plug.