LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Housing Cover and Gasket Replacement (10.5 Inch Axle) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Axle Cover Bolts, Cover And Gasket
    GM1959512Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Drain the rear axle. Refer to Rear Axle Lubricant Replacement (8.6 Inch Axle)  or Rear Axle Lubricant Replacement (10.5 Inch Axle) .
    3. IMPORTANT: Discard the axle housing cover bolts. Use NEW only.
  3. Remove the rear axle cover bolts (1), cover (2), and the gasket (3).
  4. Remove any gasket material from the rear axle housing and/or axle housing cover.
scientia non olet · About LEMON Manuals