Pinion Depth Adjustment (10.5 Inch Axle): Notes

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Install the differential, if necessary. Refer to Differential Replacement (10.5 Inch Axle) or Differential Replacement (8.6 Inch Axle) .

IMPORTANT: Measure and record the thickness of the pinion gear bearing retainer shim before any service procedures are performed to the pinion gear bearing retainer assembly.

Install the original shim to the pinion bearing retainer. If the original shim is not available, install a 0.41 mm (0.016 in) shim to build pinion depth.

IMPORTANT: Do not apply sealant to the pinion gear bearing retainer at this time.

Install the pinion gear bearing retainer.

NOTE: Refer to Fastener Notice .

Install the pinion gear bearing retainer bolts.
Tighten: Tighten the pinion gear bearing retainer bolts to 88 N.m (65 lb ft).
Adjust the backlash. Refer to Backlash Adjustment (8.6 Inch Axle) or Backlash Adjustment (10.5 Inch Axle) .
Perform a gear tooth pattern check on the pinion and the ring gear. Refer to Gear Tooth Contact Pattern Inspection .
If the gear tooth contact pattern indicates a high or a low flank contact pattern, adjust the pinion depth by doing the following:
1. Remove the pinion gear bearing retainer bolts.
2. Remove the pinion gear bearing retainer.
3. Remove the shim.
  - If the gear tooth contact pattern shows a high flank contact pattern, install a shim one size larger.
  - If the gear tooth contact pattern shows a low flank contact pattern, install a shim one size smaller.
4. Install the new shim to the pinion gear bearing retainer.
5. Install pinion gear bearing retainer.
6. Install pinion gear bearing retainer bolts.
  Tighten: Tighten the pinion gear bearing retainer bolts to 88 N.m (65 lb ft).
7. Inspect the gear tooth contact pattern of the pinion and the ring gear. Refer to Gear Tooth Contact Pattern Inspection .
8. If the gear tooth pattern is still incorrect, adjust the shim thickness as necessary and recheck the gear tooth pattern of the pinion and the ring gear.
Inspect the backlash between the pinion and the ring gear and adjust, if necessary. Refer to Backlash Adjustment (8.6 Inch Axle) or Backlash Adjustment (10.5 Inch Axle) .

The pinion shims are available in the following sizes: