LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Rear Drive Axle) >> Repair Instructions >> Differential Side Bearings Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Driving Differential Side Bearing Into Position
    GM651740Courtesy of GENERAL MOTORS CORP.
  1. For the 8.6 inch and the 10.5 inch axles, install the differential side bearings by doing the following:
    1. To protect the differential case for the 8.6 inch axle, install the J 8107-4  in the case on the side opposite the bearing installation. See Special Tools .
    2. For the 8.6 inch axle, install the J 21784  (2) and the J 8092  (1), on the differential case bearing as shown.
    3. Using a hammer and the J 21784  (2) or the J 29710  (2) and the J 8092  (1), install the side bearings.
  2. Install the differential assembly. Refer to Differential Replacement (10.5 Inch Axle)  or Differential Replacement (8.6 Inch Axle) .
scientia non olet · About LEMON Manuals