LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Rear Drive Axle) >> Repair Instructions >> Differential Carrier Bearing Preload Adjustment (10.5 Inch Axle) >> Tools Required

Tools Required

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

J 24429  Side Bearing Backlash Spanner. See Special Tools .

IMPORTANT:
  • The differential side bearing preload is adjusted by the 2 adjusting nuts in the bearing bore. The bore and the bearing cap provide the mating threads for the bearing nut.
  • The differential must be initially preloaded in order to determine the backlash of the gear set. After the backlash is set, the final bearing preload is set.
  • The rotating torque of the drive pinion must be within specifications before the pinion gear bearing retainer can be installed.
scientia non olet · About LEMON Manuals