LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 213 (Disc Brake System) >> Repair Instructions >> Rear Disc Brake Pads Replacement (2500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Disc Brake Pads & Brake Caliper Mounting Bracket
    GM369668Courtesy of GENERAL MOTORS CORP.
  1. Install NEW brake pad retaining springs to the caliper bracket.
  2. Install the brake pads to the caliper bracket.
    3. Fig 2: View Of Rear Caliper Mounting Bolts
    GM913587Courtesy of GENERAL MOTORS CORP.
  3. Install the caliper to the caliper bracket.
    4. NOTE: Refer to Fastener Notice .
  4. Install the brake caliper bolts.

    Tighten:  Tighten the bolts to 108 N.m (80 lb ft).

  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
  7. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
  8. Slowly release the brake pedal.
  9. Wait 15 seconds, then repeat steps 7-8 until a firm pedal is obtained, to properly seat the brake caliper pistons and brake pads.
  10. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling (JD9, JH6) or Master Cylinder Reservoir Filling (Two-mode Hybrid) .
  11. Burnish the pads and rotors. Refer to Brake Pad and Rotor Burnishing .
scientia non olet · About LEMON Manuals