LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 213 (Disc Brake System) >> Repair Instructions >> Rear Disc Brake Hardware Replacement (2500 Series) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing C-Clamp Over Brake Caliper - Rear
    GM687185Courtesy of GENERAL MOTORS CORP.
  1. Inspect the fluid level in the brake master cylinder reservoir.
  2. If the fluid level is midway between the maximum - full point, and the minimum allowable level, no fluid needs to be removed from the reservoir before proceeding.
  3. If the fluid level is higher than midway between the maximum - full point, and the minimum allowable level, remove fluid to the midway point before proceeding.
  4. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  5. Compress the brake caliper pistons.
    1. Install a large C-clamp over the body of the top of the caliper housing and against the back of the outboard pad.
    2. Slowly tighten the C-clamp until the pistons are pushed completely into the caliper bores.
    3. Remove the C-clamp from the caliper.
    6. Fig 2: View Of Rear Caliper Mounting Bolts
    GM913587Courtesy of GENERAL MOTORS CORP.
    CAUTION: Do not depress the brake pedal with the brake rotors/calipers and/or the brake drums removed. Damage to the brake system may result. If brake system damage occurs and is not repaired, vehicle damage and/or personal injury or death may result.
  6. Remove the brake caliper bracket bolts.
    7. NOTE: Refer to Brake Caliper Notice .
  7. Remove the caliper and caliper bracket as an assembly.
  8. Remove the brake caliper bolts.
  9. Remove the caliper from the caliper bracket.
    10. Fig 3: View Of Disc Brake Pads & Brake Caliper Mounting Bracket
    GM369668Courtesy of GENERAL MOTORS CORP.
  10. Remove the brake pads from the caliper bracket.
  11. Remove the anti-rattle clips.
    12. Fig 4: Caliper Mounting Bolt, Bracket, Boot & Slid Pins
    GM695066Courtesy of GENERAL MOTORS CORP.
  12. Remove the slide pins (5) from the caliper bracket (3).
  13. Remove the slide pin boots (4) from the caliper bracket.
  14. Inspect the disc brake hardware. Refer to Rear Disc Brake Mounting and Hardware Inspection .
scientia non olet · About LEMON Manuals