Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the brake caliper bracket.
- Perform the following procedure before installing the brake caliper bracket bolts.
- Remove all traces of the original adhesive patch.
- Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
- Apply threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
- Install the brake caliper bracket mounting bolts.
Tighten: Tighten the bolts to 200 N.m (148 lb ft).
- Install the brake pad springs.
- Install the brake pads.
- Install the brake caliper to the bracket. Refer to Front Brake Caliper Replacement (1500 Series) or Front Brake Caliper Replacement (2500 Series) .
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling (JD9, JH6) or Master Cylinder Reservoir Filling (Two-mode Hybrid) .
NOTE:
Refer to Fastener Notice
.
IMPORTANT:
Install the brake pads in the same location noted during removal.