Rear Brake Hose Replacement (Frame to Rear Axle JH6)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Brake Hose (Frame to Rear Axle JH6)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to Brake Dust Caution . CAUTION: Refer to Brake Fluid Irritant Caution . Preliminary Procedure: Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
1	Brake Pipe Fitting (Qty: 2) NOTE: Refer to Fastener Notice . Procedure Remove any dirt or debris from the brake pipe fitting. Cap the brake pipe fitting to prevent brake fluid loss and contamination. Tighten: 25 N.m (18 lb ft)
2	Hose Bracket to Frame Bolt (Qty: 2) Tighten: 25 N.m (18 lb ft)
3	Brake Pipe Fitting (Qty: 2) Procedure Remove any dirt or debris from the brake pipe fittings. Cap the brake pipe fittings to prevent brake fluid loss and contamination. Tighten: 25 N.m (18 lb ft)
4	Hose to Rear Axle Bolt Tighten: 25 N.m (18 lb ft)
5	Rear Brake Hose Assembly Procedure: Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .