LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Hydraulic Brake System) >> Repair Instructions >> Power Brake Booster Pump Fluid Accumulator Replacement (JH6) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Accumulator Components
    GM361385Courtesy of GENERAL MOTORS CORP.
  1. Lubricate all of the seals and the metal friction points with power steering fluid.
  2. Install the accumulator (2) and the O-ring seal (3).
    3. Fig 2: View Of Accumulator With C-Clamp
    GM361397Courtesy of GENERAL MOTORS CORP.
  3. Place the J 26889  over the end of the accumulator. See Special Tools .
  4. Install the nut on the stud.
  5. Depress the accumulator with a C-clamp.
    6. Fig 3: Identifying Brake Booster Retaining Ring & Access Hole
    GM360991Courtesy of GENERAL MOTORS CORP.
  6. Install the accumulator retainer ring (1).
    7. Fig 4: View Of Accumulator With C-Clamp
    GM361397Courtesy of GENERAL MOTORS CORP.
  7. Release the C-clamp.
  8. Remove the nut from the stud.
  9. Remove the J 26889  . See Special Tools .
  10. Install the master cylinder to the hydraulic booster. Refer to Master Cylinder Replacement (JD9)  or Master Cylinder Replacement (JH6)  or Master Cylinder Replacement (Two-mode Hybrid) .
  11. Release the park brake and unblock the wheels.
scientia non olet · About LEMON Manuals