Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Bench bleed the master cylinder. Refer to Master Cylinder Bench Bleeding (JD9, JH6) or Master Cylinder Bench Bleeding (Two-mode Hybrid) .
- Install the brake master cylinder seal (1) and the master cylinder to the adapter.
Ensure the brake master cylinder seal is fully seated in the groove on the master cylinder housing.
- Install 2 new brake master cylinder nuts (1).
Tighten: Tighten the nuts to 33 N.m (24 lb ft).
- Connect the brake master cylinder left front brake pipe fitting (1).
Tighten: Tighten the fitting to 30 N.m (22 lb ft).
- Connect the brake master cylinder right front brake pipe fitting (1).
Tighten: Tighten the fitting to 30 N.m (22 lb ft).
- Connect the brake master cylinder right supply brake pipe fitting (1).
Tighten: Tighten the fitting to 30 N.m (22 lb ft).
- Connect the brake master cylinder left supply brake pipe fitting (1).
Tighten: Tighten the fitting to 30 N.m (22 lb ft).
- Connect the brake master cylinder primary brake pipe fitting (1).
Tighten: Tighten the fitting to 30 N.m (22 lb ft).
- Connect the brake master cylinder reservoir return hose quick connect (1).
- Connect the brake master cylinder reservoir supply hose quick connect (2).
- Connect the brake fluid level sensor electrical connector.
- Fill the brake master cylinder reservoir. Refer to Master Cylinder Reservoir Filling (JD9, JH6) or Master Cylinder Reservoir Filling (Two-mode Hybrid) .
- Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .
NOTE:
Refer to Fastener Notice
.