LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Hydraulic Brake System) >> Repair Instructions >> Brake Master Cylinder Primary Piston Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the ignition switch in the OFF position.
  2. Disconnect the primary piston position sensor electrical connector.
    3. Fig 1: Primary Piston Position Sensor Screws & Primary Piston Position Sensor
    GM1892243Courtesy of GENERAL MOTORS CORP.
  3. Remove the 2 primary piston position sensor screws (1).
  4. Remove the primary piston position sensor (2).

    Tilt the rear of the position sensor downward and remove the sensor.

scientia non olet · About LEMON Manuals