LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Hydraulic Brake System) >> Repair Instructions >> Brake Master Cylinder Primary Piston Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Primary Piston Position Sensor
    GM1892243Courtesy of GENERAL MOTORS CORP.
  1. Install the primary piston position sensor (2).
    2. NOTE: Refer to Fastener Notice .
  2. Install the 2 primary piston position sensor screws (1).

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

  3. Connect the primary piston position sensor electrical connector.
scientia non olet · About LEMON Manuals