LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Seat Belts) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 2 Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat from the vehicle. Refer to Rear Number 2 Seat Replacement .
  2. In order to release the seat back, manually rotate the center latch. Rotate the latch until the seat back releases the seat back.
    3. Fig 1: View Of Latch Cover
    GM768624Courtesy of GENERAL MOTORS CORP.
  3. Remove the latch cover (1) from the seat.
    4. Fig 2: View Of Seat Belt Anchor Bolt (60/40 Split - 50/50 Split)
    GM768625Courtesy of GENERAL MOTORS CORP.
  4. Remove the seat belt anchor bolt (1) from the cushion frame.
  5. Remove the head rests. Refer to Head Restraint Replacement .
  6. Remove the seat back cover and pad. Refer to Rear Seat Back Cushion Cover and Pad Replacement .
  7. Remove the seat back frame. Refer to Rear Seat Back Cushion Frame Replacement .
    8. Fig 3: View Of Seatbelt Retractor Bolt Cover & Mounting Bolts
    GM768626Courtesy of GENERAL MOTORS CORP.
  8. Remove the seatbelt retractor bolt cover (1).
  9. Remove the retractor mounting bolts (2).
    10. Fig 4: View Of Handle Mounting Screws
    GM768627Courtesy of GENERAL MOTORS CORP.
  10. Remove the handle mounting screws (1).
  11. Partially remove the seat cushion cover by separating the cushion trim J-strips.
    12. Fig 5: View Of No. 2 Rear Seat Belt Buckle (60/40 Split - 50/50 Split)
    GM768629Courtesy of GENERAL MOTORS CORP.
  12. Remove the bolts attaching the buckle to the seat cushion frame.
  13. Remove the buckle and the latch from the seat frame.
scientia non olet · About LEMON Manuals