LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Seat Belts) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 1 Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door sill plate. Refer to Front Side Door Sill Plate Replacement or Rear Side Door Sill Plate Replacement .
  2. Remove the lower anchor bolt from bodyside panel.
  3. Remove the lock pillar trim panel. Refer to Body Lock Pillar Trim Panel Replacement .
  4. Route the belt through trim panel.
    5. Fig 1: Locating Upper Guide Bolt
    GM833563Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolt from the upper guide.
  6. Remove the bolt from the retractor.
  7. Remove the seatbelt anchor bolt cover.
  8. Remove the floor anchor bolt.
  9. Remove the assembly from the vehicle.
scientia non olet · About LEMON Manuals