LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Seat Belts) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 1 Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the assembly to vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the bolt to the retractor.

    Tighten:  Tighten the bolt to 55 N.m (41 lb ft).

  3. Install the bolt to the upper guide.

    Tighten:  Tighten the bolt to 55 N.m (41 lb ft).

    4. Fig 1: Locating Upper Guide Bolt
    GM833563Courtesy of GENERAL MOTORS CORP.
  4. Route the belt through trim panel.
  5. Install the lock pillar trim panel. Refer to Body Lock Pillar Trim Panel Replacement .
  6. Install the lower anchor bolt to bodyside panel.

    Tighten:  Tighten the bolt to 55 N.m (41 lb ft).

  7. Install the floor anchor bolt.

    Tighten:  Tighten the bolt to 55 N.m (41 lb ft).

  8. Install the seat belt anchor bolt cover.
  9. Install the door sill plate. Refer to Front Side Door Sill Plate Replacement or Rear Side Door Sill Plate Replacement .
scientia non olet · About LEMON Manuals