LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Seat Belts) >> Repair Instructions >> Seat Belt Retractor Replacement - Left Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Move the front seat to the full forward position.
    2. IMPORTANT: Do not remove the seat back cover from the head restraint retainers.
  2. Remove the seat back cover and pad. Refer to Front Seat Back Cover and Cushion Pad Replacement .
  3. Separate the seat foam from the cardboard to gain access to the retainer on the seat belt side.
  4. Remove the seat belt side cardboard retainers.
  5. Move the cardboard outwards to gain access to the lower seat belt retractor bolt.
    6. Fig 1: View Of Lower Seat Belt Retractor Bolt
    GM792223Courtesy of GENERAL MOTORS CORP.
  6. Remove the retractor bolt.
    7. Fig 2: Locating Retractor Tower Retaining Screw
    GM381472Courtesy of GENERAL MOTORS CORP.
  7. Remove the retractor tower retaining screw.
  8. Remove the retractor tower cover.
    9. Fig 3: View Of Upper Anchor Bolt
    GM792224Courtesy of GENERAL MOTORS CORP.
  9. Remove the upper anchor bolt.
  10. Remove the retractor from the seat.
scientia non olet · About LEMON Manuals