LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Seat Belts) >> Repair Instructions >> Seat Belt Retractor Replacement - Left Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat belt retractor onto the seat.

    Line up the tab on the retractor to the tab on the seat frame.

    2. Fig 1: View Of Upper Anchor Bolt
    GM792224Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the upper anchor bolt.

    Tighten:  Tighten the bolt to 53 N.m (39 lb ft).

    3. Fig 2: Locating Retractor Tower Retaining Screw
    GM381472Courtesy of GENERAL MOTORS CORP.
  3. Install the retractor tower cover.
  4. Install the retractor tower cover retaining screw.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

    5. Fig 3: View Of Lower Seat Belt Retractor Bolt
    GM792223Courtesy of GENERAL MOTORS CORP.
  5. Install the retractor.
  6. Install the retractor bolt.

    Tighten:  Tighten the bolt to 53 N.m (39 lb ft).

  7. Install the rear cardboard panel retainers.
  8. Install the seat back cover and pad. Refer to Front Seat Back Cover and Cushion Pad Replacement .
  9. Move the seat to its original position.
scientia non olet · About LEMON Manuals