Seat Belt Stop Button Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Work the male half of the stop button through the hole in the webbing or at the marked location.
- Align the female half of the stop button with the male half of the stop button.
- Snap the two halves together.
- Trim off any access of the male half of the stop button flush with the female half of the stop button.
NOTE:
Ensure the male half of the stop button is facing forward in the vehicle in order to ensure the stop button will not snag customers clothing.