LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Seat Belts) >> Repair Instructions >> Seat Belt Latch Stop Installation >> Preliminary Procedure

Preliminary Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Locate the hole in the seat belt webbing where the original seat belt stop button was located.
  2. If the original hole in the seat belt webbing is not visible, perform the following:
    • If either the right or left stop button is missing use the opposing seat belt as a reference.
    • With the opposing seat belt fully stowed, measure the distance between the seat belt lower anchor and the stop button.
    • Using the measurement obtained above, measure and mark the location of the missing stop button on the center of the seat belt webbing.
  3. Ensure the seat belt latch plate is located above the mark or original hole.
scientia non olet · About LEMON Manuals