LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Seat Belts) >> Repair Instructions >> Seat Belt Buckle and Latch Replacement - No. 2 Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of No. 2 Rear Seat Belt Buckle (60/40 Split - 50/50 Split)
    GM768629Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the buckle to the seat frame.
  2. Install the buckle bolts.

    Tighten:  Tighten the bolts to 53 N.m (39 lb ft).

    3. Fig 2: View Of Handle Mounting Screws
    GM768627Courtesy of GENERAL MOTORS CORP.
  3. Connect the seat cushion cover by joining the cushion J-strips.
  4. Install the handle mounting screws.

    Tighten:  Tighten the screws to 7 N.m (61 lb in).

scientia non olet · About LEMON Manuals