LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 209 (Anti-Lock Brake System - Hybrid) >> Repair Instructions >> Rear Wheel Speed Sensor Ring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement .
  4. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.6 Inch axle) or Rear Axle Housing Cover and Gasket Replacement (10.5 Inch Axle) .
  5. Remove the axle shaft. Refer to Rear Axle Shaft Replacement .
    6. Fig 1: View Of Wheel Speed Sensor Ring, Axle Housing & Removal Tool
    GM889095Courtesy of GENERAL MOTORS CORP.
  6. Remove the axle shaft seal, the bearing and the wheel speed sensor ring from the axle housing using the J 45857  (1) and the J 2619-01  (2). See Special Tools .
scientia non olet · About LEMON Manuals