Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Wheel Speed Sensor

Courtesy of GENERAL MOTORS CORP.

Using a twisting motion, install the wheel speed sensor until fully seated.

NOTE: Refer to Fastener Notice .

Install the wheel speed sensor retaining bolt.
Tighten: Tighten the wheel speed sensor retaining bolt to 13 N.m (115 lb in).
Connect the electrical connector.
Install the wheel speed sensor wiring harness to the retainers.
Lower the vehicle.
Perform the Diagnostic System Check - Vehicle (without HP2) or Diagnostic System Check - Vehicle (with HP2) .