Driver or Passenger Seat Cushion Heater Replacement (without HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Driver or Passenger Seat Cushion Heater (without HP2)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the front seat. Refer to Front Seat Replacement - Bucket (without HP2) or Front Seat Replacement - Bucket (with HP2) .
1	Front Seat Recliner Lever Procedure: Using a flat-bladed tool, push the retainer clip downward and pull outward to release the lever.
2	Front Seat Manual Lumbar Knob Procedure: Using a flat-bladed tool, push the retainer clip downward and pull outward to release the knob.
3	Front Seat Adjuster Outer Finish Cover Refer to Front Seat Cushion Outer Trim Panel Replacement (with HP2) or Front Seat Cushion Outer Trim Panel Replacement (Manual Seat without HP2) or Front Seat Cushion Outer Trim Panel Replacement (Power Seat without HP2) .
4	Front Seat Adjuster Inner Finish Cover Refer to Front Seat Cushion Inner Trim Panel Replacement (with HP2) or Front Seat Cushion Inner Trim Panel Replacement (without HP2) .
5	Front Seat Riser Finish Cover Procedure: Pull rearward to disengage the cover from the seat riser.
6	Front Seat Cushion Cover and Pad Procedure Disengage the j-channel retainers from the seat cushion frame. Remove the seat cushion cover and pad from the seat cushion frame as an assembly.
7	Front Seat Cushion Heater Element Procedure Disconnect the heater element and peel away from the cushion to remove. If working on the passenger seat, re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References .