Circuit/System Description

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The heat and cool seat functions for both the driver and passenger seats is controlled by the climate control seat module that is located under the passenger seat cushion. The heated and cooled seat switches are located in the HVAC control module. When a heated or cooled seat switch is pressed a serial data message from the HVAC control module is sent to the memory seat module (MSM) indicating the heat/cool seat request. The MSM then sends a pulse width modulation (PWM) signal through the appropriate heated/cooled seat mode signal circuit to the climate control seat module (CCSM) to activate the heated or cooled seat function. The CCSM then applies battery voltage to the seat cushion and seat back thermal electronic devices (TEDs) and a pre-determined voltage to the blower motors. To determine seat temperature, the CCSM supplies a 5 volt signal and a low reference to the temperature sensors that are attached to each TED. The temperature sensors are variable resistors, their resistance changes as the temperature of the seat changes. Then based on the seat temperature, the CCSM controls the voltage level that it applies to the TEDs and blower motors.