LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Seat Heating System & Seat Cooling System) >> Diagnostic Information and Procedures >> Heated Seat Inoperative - Rear >> Circuit/System Description

Circuit/System Description

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The left and right rear passenger heated seats are controlled by separate heated seat switches located in the auxiliary heater and air conditioning control module. The heated seats operate in the high and low modes for the seat cushion only. When a heated seat switch is pressed, the auxiliary heater and air conditioning control module illuminates appropriate switch indicators and sends a serial data message to the rear heated seat module (RHSM) indicating the heated seat request. The RHSM then determines the mode of operation and turns the heated seat system ON or OFF.