LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Seat Heating System & Seat Cooling System) >> Diagnostic Information and Procedures >> Heated Seat Inoperative (Chevy and GMC) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the appropriate scan tool Driver Door Switch or Passenger Door Switch parameters listed below while pressing and releasing the appropriate switch. The readings should change between Inactive and Active.
    • Seat Back Heat Mode Sw.
    • Seat Heat Mode Sw.
    • If not the specified values, refer to the Heated Seat Switch component test below. If the heated seat switch tests normal, replace the appropriate door module
  2. If all scan tool parameters test normal and there are no DTCs set, replace the MSM/HSM.
  3. If all heated seat functions operate normal and the heated seat switch indicators do not illuminate, refer to the Heated Seat Switch Indicators component test below.
scientia non olet · About LEMON Manuals