B2345 00

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Ignition OFF, disconnect the X1 harness connector at the HSM.
Test for infinite resistance between the control circuit terminal 6 and ground.
- If not the specified value, test the control circuits listed below for a short to ground:
  - Driver seat cushion and seat back terminal 6
  - Driver seat cushion element terminal 5
  - Driver seat back element terminal 1
Test for infinite resistance between the control circuit terminal 3 and ground.
- If not the specified value, test the control circuits listed below for a short to ground:
  - Passenger seat cushion and seat back terminal 3
  - Passenger seat cushion element terminal 2
  - Passenger seat back element terminal 4
Ignition ON, verify that a test lamp does not illuminate between the control circuit terminal 6 and ground.
- If the test lamp illuminates, test the control circuits listed below for a short to voltage:
  - Driver seat cushion and seat back terminal 6
  - Driver seat cushion element terminal 5
  - Driver seat back element terminal 1
Verify that a test lamp does not illuminate between the supply voltage circuit terminal 3 and ground.
- If the test lamp illuminates, test the control circuits listed below for a short to voltage:
  - Passenger seat cushion and seat back terminal 3
  - Passenger seat cushion element terminal 2
  - Passenger seat back element terminal 4
If all circuits test normal, replace the HSM.