LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Seat Heating System & Seat Cooling System) >> Diagnostic Information and Procedures >> DTC B2345 (Rear Heated Seat Module) >> Circuit/System Testing >> B2345 13

B2345 13

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X2, X4 harness connectors at the RHSM.
  2. Test for greater than 850 ohms between the signal and the low reference circuits listed below:
    • Left rear seat terminal 9 X4 and terminal 6 X2
    • Right rear seat terminal 20 X4 and terminal 8 X2
    • If less than the specified value, test for a short between the signal and low reference circuits. If the circuits test normal, replace the appropriate seat cushion heater element/temperature sensor.
  3. If all circuits test normal, replace the RHSM.
scientia non olet · About LEMON Manuals