LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 206 (Power Seat System) >> Diagnostic Information and Procedures >> Power Seat Inoperative (Without Memory A45 ) >> Component Testing >> Seat Adjuster Switch Test

Seat Adjuster Switch Test

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the seat adjuster switch.
  2. Test for infinite resistance between each control terminal and the B+ terminal with the switch in the open position.
    • If less than the specified value, replace the seat adjuster switch.
  3. Test for less than 1 ohm between each control terminal and the B+ terminal with the switch in the closed position.
    • If greater than the specified range, replace the seat adjuster switch.
  4. Test for less than 1 ohm between each control terminal and the ground terminal with the switch in the open position.
    • If greater than the specified range, replace the seat adjuster switch.
scientia non olet · About LEMON Manuals