LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 206 (Power Seat System) >> Diagnostic Information and Procedures >> Power Folding Seat Inoperative >> Circuit/System Testing >> Folding Seat Switch Circuit Test

Folding Seat Switch Circuit Test

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the harness connector at the inoperative rear folding seat switch.
  2. Verify that a test lamp illuminates between the appropriate B+ circuit listed below and ground:
    • Front Rear Folding Seat Switch terminal 1
    • Left or Right Rear Folding Seat Switch terminal C
    • If the test lamp does not illuminate test the switch supply circuit for an open or high resistance. If the circuit tests normal replace the left I/P junction block.
  3. If the circuits test normal, test or replace the folding seat switch.
scientia non olet · About LEMON Manuals