LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 202 (Adjustable Pedal System) >> Repair Instructions >> Accelerator Pedal Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Ensure the brake pedal assembly is adjusted to the lowest position farthest from the drivers seat prior to removal of the accelerator assembly. Failure to do so could result in incorrect step-over height between the brake and accelerator pedals and improper function of the adjustable pedal system.
  1. Remove the driver knee bolster. Refer to Knee Bolster Replacement (Except Cadillac) or Knee Bolster Replacement (Cadillac) .
  2. Remove the accelerator pedal position sensor assembly. Refer to Accelerator Pedal Position Sensor Replacement .
  3. Remove the accelerator pedal bracket nuts.
    4. Fig 1: View Of Accelerator Pedal Actuator Cable Housing
    GM1712026Courtesy of GENERAL MOTORS CORP.
  4. Remove the adjustable pedal drive cable from the accelerator pedal actuator using the following procedure:
    1. Twist the cable housing counterclockwise.
    2. Compress the secondary locking tabs located below the twist and lock tabs with a pointed tool and remove the cable from the pedal actuator.
    5. Fig 2: View Of Accelerator Pedal Bracket Nuts
    GM1711979Courtesy of GENERAL MOTORS CORP.
  5. Remove the accelerator pedal bracket nuts from the accelerator pedal bracket.
    6. Fig 3: View Of Accelerator Actuator Lower Pivot Pin Push Nut, Pivot Pin & Washer
    GM1713412Courtesy of GENERAL MOTORS CORP.
  6. Remove the accelerator actuator lower pivot pin push nut (1) and washer (2).
  7. Remove the accelerator actuator lower pivot pin (3).
    8. Fig 4: View Of Accelerator Actuator & Actuator Mounting Screws
    GM1713410Courtesy of GENERAL MOTORS CORP.
  8. Remove the accelerator actuator mounting screws (1).
  9. Remove the accelerator actuator (2).
scientia non olet · About LEMON Manuals