Vehicle Jacking

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Park the vehicle on a clean, hard, level surface before jacking the vehicle.
Any time you lift the vehicle on one end, chock the wheels at the opposite end.
Use jack stands in order to provide support.
When supporting the vehicle using jack stands, place the jack stands under the side rails or the axle.
When lifting under the rear differential, do not allow the jack pad to contact the rear stabilizer bar or mounting hardware.