LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Vehicle Access) >> Repair Instructions >> Opening the Midgate When There Is an Electrical Failure >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the midgate inner panel. Refer to Midgate Inner Panel Replacement .
  2. Lower the midgate window.
    3. NOTE: Removal of the mid gate window sealing strip with the mid gate closed will damage the sealing strip, requiring a new sealing strip for installation.
  3. Remove the midgate window sealing strip, by lifting the seal off the midgate inner and outer flanges. Refer to Midgate Window Outer Sealing Strip Replacement .
    4. Fig 1: Releasing The Midgate Latches
    GM1239376Courtesy of GENERAL MOTORS CORP.
  4. Insert a flat-bladed tool between the midgate reinforcement (3) and the window run channel (1).
  5. Slide the manual release levers (2) downward to release the midgate latches.
  6. Diagnose and repair the midgate latches.
scientia non olet · About LEMON Manuals