LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Vehicle Access) >> Repair Instructions >> Liftgate Lock Plate and Rod Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Liftgate Lock Plate & Rod
    GM831459Courtesy of GENERAL MOTORS CORP.
  1. Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
  2. Disconnect the lock actuator electrical connection.
  3. Disconnect the latch control cables by releasing the retainers (2) and removing the cable ends from the cups. Note the routing.
  4. Remove the fasteners (1) retaining the control assembly to the liftgate.
  5. Remove the lock plate assembly from the liftgate.
scientia non olet · About LEMON Manuals