LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Vehicle Access) >> Repair Instructions >> Liftgate Lock Plate and Rod Replacement >> Installation Procedures

Installation Procedures

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Liftgate Lock Plate & Rod
    GM831459Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Position the lock plate assembly in place on the liftgate, and install the fasteners (1) retaining the control assembly to the liftgate.

    Tighten:  Tighten the fasteners to 9 N.m (80 lb in).

  2. Connect the latch control cables (2) to the control assembly by placing the cable ends in their cups and securing the retainers. Note the proper routing.
  3. Connect the lock actuator electrical connector.
  4. Inspect for proper operation.
  5. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
scientia non olet · About LEMON Manuals