LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Vehicle Access) >> Repair Instructions >> Liftgate Lock Actuator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
  2. Disconnect the lock actuator electrical connector.
    3. Fig 1: Liftgate Lock Actuator
    GM832256Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Note location of arm prior to removal.
  3. Remove the fastener (1) retaining the control arm to the actuator.
  4. Remove the fastener (2) retaining the actuator to control arm assembly plate,
  5. Slide the actuator upward, and remove the actuator from the plate.
scientia non olet · About LEMON Manuals