LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Vehicle Access) >> Repair Instructions >> Liftgate Lock Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Liftgate Lock Actuator
    GM832256Courtesy of GENERAL MOTORS CORP.
  1. Align the tabs on the actuator to the grooves (3) on the control assembly plate, and slide the actuator down into position.
    2. NOTE: Refer to Fastener Notice .
  2. Install fastener (2) retaining the actuator to the control assembly plate.
    3. IMPORTANT: Install the control arm in the position noted during removal.
  3. Install fastener (1) retaining the control arm to the actuator.

    Tighten:  Tighten the fasteners to 2 N.m (18 lb in).

  4. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .

    Tighten:  Tighten the fastener to 2 N.m (18 lb in).

scientia non olet · About LEMON Manuals