Removal Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Open the door.
- Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
- Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
- Remove the window run channel. Refer to Front Side Door Window Channel Replacement .
- Disconnect the lock actuator electrical connector.
- Disconnect the outside door handle rod (1) by releasing the retaining clip on the door latch.
- Disconnect the lock cylinder rod by releasing the retaining clip (1).
- Remove the manual locking rod from the door by releasing the rod from the retainers.
- Remove the fasteners (2) retaining the door latch (1) to the door.
- Remove the door latch (1).