LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Vehicle Access) >> Repair Instructions >> Front Side Door Inside Handle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Inside Door Handle
    GM862267Courtesy of GENERAL MOTORS CORP.
  1. Position the door handle in the retention slots.
    2. NOTE: Refer to Fastener Notice .
  2. Install the fastener (2) retaining the door handle to the door.

    Tighten:  Tighten the fastener to 9 N.m (80 lb in).

  3. Attach the inside door handle rod retention clip (1).
  4. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
  5. Close the door.
scientia non olet · About LEMON Manuals