LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Vehicle Access) >> Repair Instructions >> Endgate Latch Replacement - Left Side Upper >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the spare tire carrier to a full outward position.
    2. Fig 1: Endgate Trim Bezel
    GM1412524Courtesy of GENERAL MOTORS CORP.
  2. Remove the endgate trim bezel.
  3. Open the endgate.
    4. Fig 2: Endgate Lock Rod Clip
    GM1412523Courtesy of GENERAL MOTORS CORP.
  4. Release the endgate lock rod clip (1) from the handle.
  5. Release the left side cable from the upper bolt.
    6. Fig 3: Latch Mechanism
    GM1428254Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolts from the latch mechanism. Note the cable bolt is shoulder for the cable.
  7. Carefully pull the latch outward and release the lock rod clip (3) from the lock rod (4).
  8. Remove the latch from the endgate.
scientia non olet · About LEMON Manuals