LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Vehicle Access) >> Repair Instructions >> Endgate Handle Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Swing the spare tire carrier to the full outward position.
    2. Fig 1: Endgate Trim Bezel
    GM1412524Courtesy of GENERAL MOTORS CORP.
  2. Remove the trim panel bezel from the endgate.
  3. Open the endgate.
    4. Fig 2: Lock Rod Retaining Clips
    GM1428164Courtesy of GENERAL MOTORS CORP.
  4. Release the 2 lock rod retaining clips (4, 5) from the lock rods (1, 3).
  5. Release the lock rods from the handle assembly.
    6. Fig 3: Endgate Handle
    GM1412522Courtesy of GENERAL MOTORS CORP.
  6. Remove the 3 screws from the handle.
  7. Rotate the handle downward.
  8. Remove the handle from the endgate.
scientia non olet · About LEMON Manuals