LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Vehicle Access) >> Repair Instructions >> Door Striker Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Door Lock Striker
    GM838823Courtesy of GENERAL MOTORS CORP.
  1. Align the striker with the alignment marks made with the grease pencil.
    2. NOTE: Refer to Fastener Notice .
  2. Install the fasteners retaining the striker to the door frame.

    Tighten:  Tighten the fasteners to 27 N.m (20 lb ft).

  3. Operate the door to check for proper operation and alignment.
scientia non olet · About LEMON Manuals