LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Vehicle Access) >> Diagnostic Information and Procedures >> Scan Tool Data List

Scan Tool Data List

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Driver Door Module/Passenger Door Module

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: Ignition ON/Engine OFF/Vehicle in PARK/All Doors Closed
Battery 1 (Low Current) Data Volts 12.8
Battery 2 (High Current) Data Volts 12.8
Boot S/W Part No. Module Information 1 Decimal 15XXXXXX
Boot S/W Suffix Module Information 1 ASCII XX
Cal. Module 1 Part No. Module Information 2 Decimal 15XXXXXX
Cal. Module 1 Suffix Module Information 2 ASCII XX
Cal. Module 2 Part No. Module Information 2 Decimal 15XXXXXX
Cal. Module 2 Suffix Module Information 2 ASCII XX
Door Ajar Switch Inputs On, Off Off
Door Key Unlock Inputs Inactive/Active Inactive
Door Lock Motor Outputs Idle, Lock, Unlock Idle
Door Lock Switch Inputs Idle, Lock, Unlock Idle
Operational S/W Part No. Module Information 1 Decimal 15XXXXXX
Operational S/W Suffix Module Information 1 ASCII XX
Body Control Module

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: Ignition ON/Engine OFF/Vehicle in PARK/All doors closed
Battery Voltage Data Volts Varies
Door Lock Switch Inputs Inactive/Active Inactive
Door Unlock Switch Inputs Inactive/Active Inactive
Driver Door Unlock Relay Outputs On/Off Off
Key in Ignition Inputs Yes/No Yes
Left Rear Door Ajar Sw. Inputs On/Off Off
Right Rear Door Ajar Sw. Inputs On/Off Off
Rear Door Lock Relay Outputs On/Off Off